ANDERSON METALS COMPRESSION SLEEVE, BRASS, 1/4 IN.

Description

1/4", Brass, Compression Sleeve, Lead free compliant product which meets Public Law 111-380, bulk.

• Compliant product which meets California AB-1953
• Compliant product which meets Vermont SB-152
• Three piece construction - nut, sleeve (or ferrule) and body
• Use with copper, aluminum or plastic tubing (plastic requires 60P sleeve and 61P insert)
• Negative 65 degrees to plus 250 degrees F. temperature range
• Standard fittings use short nuts. Long nuts are available for higher vibrations applications
• To buy compression fittings with long nut, please add a "1" in front of the part number. (i.e. 68 = 168)
• Easy to disassemble, no flaring tool required
• Primary uses: water, gasoline, oil and vacuum lines

To assemble:

1. Cut smooth, square end on tubing
2. Slide nut, then sleeve onto tube. Thread must face end
3. Insert tube into fitting
4. Thread nut onto fitting until snug, then as follows: up to 1/4 inch = 1-1/4 turns, 5/16 inch = 1-3/4 turns, 3/8 inch and up = 2-1/4 turns